BambuLab P1S 3d Printer

3d Printing Workflow

On your computer

1. Create your model using Tinkercad or OnShape.
   • We only print models someone else created with Dr. Taylor's permission.
2. Export the model using STEP, 3MF, or STL format.
3. Upload the model to https://link.rstem.net/up.

On the Laser Computer

1. Download the model from where you stored it at https://link.rstem.net/up.
2. Open the OrcaSlicer Application.
3. Create a New Project.
4. Drag the model file from the Downloads folder.
5. Check for appropriate settings on the left. Especially, verify these settings are correct:
   • Supports-You need them if there are large overhangs.
   • Brim-A brim can help prints stay on the bed.
   • Infill-Use enough for the strength you need. That will likely never be more than 15%.
   • Printer type-Make sure it says P1S.
   • Filament type-You are most likely going to be using PETG.
6. Slice the file (Top right)
7. Export the sliced file to an SD card.

On the Printer

1. Verify:
   • The printer has a clean build plate installed correctly.
   • The correct filament is on the back.
     • Check out [P1S Filament Change] if it isn't.
2. Swap SD cards, putting the old one back in the yellow tray.
3. Go to the folder icon on the left.
4. Select your file, and hit print!