More actions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
[[File:vinylcutter.jpg|thumb|center|400px|US Cutter MH-871-MK2]] | [[File:vinylcutter.jpg|thumb|center|400px|US Cutter MH-871-MK2]] | ||
= Usage = | |||
To use the vinyl cutter, begin by producing the graphics you'd like to cut in Inkscape or Illustrator. It is only controllable using VinylMaster software on Dr. Taylor's computer, so he'll help you do the actual cutting. | |||
= Settings = | |||
* Heat Transfer Vinyl | |||
** Start with 230 mm/s at 100g to remove just the backing (without cutting all of the way through) | |||
* Adhesive Vinyl | |||
** 230 mm/s at 150g | |||
[[Category:Tool]] | [[Category:Tool]] | ||
Revision as of 15:32, 7 February 2025
Usage
To use the vinyl cutter, begin by producing the graphics you'd like to cut in Inkscape or Illustrator. It is only controllable using VinylMaster software on Dr. Taylor's computer, so he'll help you do the actual cutting.
Settings
- Heat Transfer Vinyl
- Start with 230 mm/s at 100g to remove just the backing (without cutting all of the way through)
- Adhesive Vinyl
- 230 mm/s at 150g