More actions
No edit summary |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File:vinylcutter.jpg|thumb|center|400px|US Cutter MH-871-MK2]] | [[File:vinylcutter.jpg|thumb|center|400px|US Cutter MH-871-MK2]] | ||
= Usage = | |||
To use the vinyl cutter, begin by producing the graphics you'd like to cut in Inkscape or Illustrator. It is only controllable using VinylMaster software on Dr. Taylor's computer, so he'll help you do the actual cutting. | |||
= Settings = | |||
* Heat Transfer Vinyl | |||
** Start with 230 mm/s at 110g to remove just the backing (without cutting all of the way through) | |||
** For the heat press, use about 305 F for 12-15s | |||
* Adhesive Vinyl | |||
** 230 mm/s at 150g | |||
[[Category:Tool]] | [[Category:Tool]] | ||
Latest revision as of 04:27, 8 February 2025
Usage
To use the vinyl cutter, begin by producing the graphics you'd like to cut in Inkscape or Illustrator. It is only controllable using VinylMaster software on Dr. Taylor's computer, so he'll help you do the actual cutting.
Settings
- Heat Transfer Vinyl
- Start with 230 mm/s at 110g to remove just the backing (without cutting all of the way through)
- For the heat press, use about 305 F for 12-15s
- Adhesive Vinyl
- 230 mm/s at 150g