More actions
No edit summary |
m Ptaylor moved page BambuLab P1S to BambuLab P1S 3d Printer |
||
| (10 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File:3dprinters.jpg|center|400px]] | [[File:3dprinters.jpg|center|400px|Some of the P1S printers.]] | ||
== 3d Printing Workflow == | == 3d Printing Workflow == | ||
=== On your computer === | === On your computer === | ||
[[File:3dpbadgereqd.png|thumb|left|100px||link=3D_Printing_Badge]] | |||
# Create your model using [https://tinkercad.com Tinkercad] or [https://onshape.com OnShape]. | # Create your model using [https://tinkercad.com Tinkercad] or [https://onshape.com OnShape]. | ||
#* We only print models someone else created with Dr. Taylor's permission. | #* We only print models someone else created with Dr. Taylor's permission. | ||
# Export the model using STEP, 3MF, or STL format. | # Export the model using STEP, 3MF, or STL format. | ||
# Upload the model to | # Upload the model to the red link on the board. | ||
=== On the Laser Computer === | === On the Laser Computer === | ||
[[File:Exportsliced.png|thumb|300px|Drop-down menu]] | [[File:Exportsliced.png|thumb|300px|Drop-down menu]] | ||
# Download the model from where you stored it at | # Download the model from where you stored it at the red link on the board. | ||
# Open the OrcaSlicer Application. | # Open the OrcaSlicer Application. | ||
# Create a New Project. | # Create a New Project. | ||
| Line 25: | Line 26: | ||
=== On the Printer === | === On the Printer === | ||
[[File:p1sfiles.jpg|300px|thumb|The file menu.]] | |||
# Verify: | # Verify: | ||
#* The printer has a clean build plate installed correctly. | #* The printer has a clean build plate installed correctly. | ||
Latest revision as of 20:16, 28 January 2025
3d Printing Workflow
On your computer
- Create your model using Tinkercad or OnShape.
- We only print models someone else created with Dr. Taylor's permission.
- Export the model using STEP, 3MF, or STL format.
- Upload the model to the red link on the board.
On the Laser Computer
- Download the model from where you stored it at the red link on the board.
- Open the OrcaSlicer Application.
- Create a New Project.
- Drag the model file from the Downloads folder.
- Check for appropriate settings on the left. Especially, verify these settings are correct:
- Supports-You need them if there are large overhangs.
- Brim-A brim can help prints stay on the bed.
- Infill-Use enough for the strength you need. That will likely never be more than 15%.
- Printer type-Make sure it says P1S.
- Filament type-You are most likely going to be using PETG.
- Slice the file (Top right)
- Export the sliced file to an SD card.
On the Printer
- Verify:
- The printer has a clean build plate installed correctly.
- The correct filament is on the back.
- Check out P1S Filament Change if it isn't.
- Swap SD cards, putting the old one back in the yellow tray.
- Go to the folder icon on the left.
- Select your file, and hit print!